carl
True Classic
What is the typical failure mode for these plastic bushings? I have the rack on the work bench and the boot removed. I don't see any pieces of the bushing but I do see what might be the bushing pushed further into the housing tube. Do the locating tabs break and the bushing just gets pushed in? If that's the case, how do you remove it or do you just leave it and install a new one? If you can pull it back into it's proper position has anyone used screws or other externally applied fasteners to relocate the old bushing in it's proper place?
I have not yet tried to loosen and remove the universal joint from the steering rack, the last time I tried this on another X I could not get it loose. The universal is not a reverse thread, right?
I have not yet tried to loosen and remove the universal joint from the steering rack, the last time I tried this on another X I could not get it loose. The universal is not a reverse thread, right?