Rubber stripping

What is this rubber stripping called so I can look it up on Midwest Bayless?

MWB calls it Weatherstrip Door Seal...

http://www.midwest-bayless.com/p-13...-left-and-right-set-fiat-x19-1973-78-new.aspx

($106)

NOTE: CUT OFF AND save the corner LUGS with the MWB kit.

MWB also offers this

http://www.midwest-bayless.com/p-13...ft-or-right-fiat-bertone-x19-1974-88-new.aspx

and TWO will be needed. ($109)

OR...

Replace with the same or CUT off the CORNERS and reuse with something LIKE this.

http://www.carid.com/cr-laurence/25...n-st36a.html?gclid=CP2e3NPU5cgCFQeOaQodaMEAoQ

25 feet should be plenty to start at the top of the windshield, go down, across, up and across the Targa, and then repeat on the other side to the top of the W/S again. This on is a bit expensive at over $2.50 a foot. ($63)

New Corners can be had from Ricardo Borja... page him here and tell him I sent ya so's I gets my cut.

I prefer to use the rubber bulb door molding all around in ONE piece with NO CORNERS for a clean look. It does not seal the top as well but I dunno if I can find my top anyway...



Expand this shot and look at the corners on the Targa bar...

Watch this Video... this company offers the bulb trim at about $250 a foot so you can order the exact amount you need. Remove the old trim toi get the exact length.

https://www.iowa80.com/DirectionsWE...hannel+Width&gclid=CIO09dra5cgCFYM6aQodAXgG1A

Lastly... DON'T YOU DARE DO ANYTHING BEFORE THAT CHOKE CABLE IS INSTALLED, Renea!

This stuff is a perfect fit:



I've used it on my X1/9 & 850 restorations

Thank you, Tony!

Thank you, Mark! :heart:

Choke cable

Will do on the choke cable!