This is a PBS DOHC motor based on the 843cc 850 block. Not shown are the twin 40DCOE's used for induction. I never installed/ran the motor but did remove the lower pan for inspection. It looked new inside! I understand it was in a D-Sports racer for one season around 1968-9 and then put in storage. Inside the block the following was stamped on the center web: JIM 101HP. I assume Jim was the builder and 101 HP was the dyno number. It now lives in Japan in a coach built Abarth. I considered putting it in my '67 850 Spider but figured the torque curve would be way off.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.