lookforjoe
True Classic
Finally pulled the cluster & dismantled for conversion. Swapped gauge face, opened up cluster recess for the electronic speedo following Yves's photos as a guide. Placed the circuit inside the cluster.
cut the later speedo reset in half - 15mm was the appropriate measured depth to allow the X1/9 reset button to reach the reset lever of the electronic speedo.
drilled out the mount holes & reused the electronic speedo isolater plate & washers. Power & ground taken off the close pins. Have to add a connection for the wire that will feed from the SpeedoHealer.
cut the later speedo reset in half - 15mm was the appropriate measured depth to allow the X1/9 reset button to reach the reset lever of the electronic speedo.
drilled out the mount holes & reused the electronic speedo isolater plate & washers. Power & ground taken off the close pins. Have to add a connection for the wire that will feed from the SpeedoHealer.